Take Pictures Further
Service and Support
Service & Support Main |  dc3400 Support |  User's Guide Contents |  Previous |  Next


KODAK DC3400 Zoom Digital Camera
User's Guide
Connecting to a Macintosh Computer

Either a serial cable for a Macintosh computer or adapter plug for use with the RS-232 serial cable is provided so that you can connect your camera through a serial port on a Macintosh computer.

  1. Set the Mode dial to Connect.

  2. Connect the serial port adapter plug into the 9-pin end of the serial cable.

  3. Plug the adapter end of the serial cable into an available serial port on the back of the computer.

    If your camera came with a serial cable for a Macintosh computer instead of the serial adapter plug, connect the end of the serial cable labeled MAC into the available serial port on the back of the computer.

    Serial ports on Macintosh computers are usually referred to as modem or printer ports.

    If the ports are not labeled, see your computer User's Guide for a diagram that illustrates all of the external ports.

  4. Open the serial/USB port door on the side of the camera.

  5. Plug the other end of the serial cable into the camera serial port.

  6. Slide the POWER switch to the right to turn on the camera.

    If you get a message on your computer stating that you are not connected, refer to the Connect.PDF document installed with the software, or the online help for troubleshooting information.

Previous |  Next

User's Guide Contents
Main Table of Contents
Installing Your Software:
Using Serial Cable Connection | Connecting Windows Computer | Connecting Macintosh Computer | Using USB Cable Connection | Starting Software-Windows Computers | Starting Software-Macintosh Computers | Navigating Pictures